Wow, that was a quick answer- many thanks! Unfortunately I followd your instructions and it did not work. Firstly let me clarify that SATA 0 is the socket on the top left, as shown?
The messages are as follows:
Drive 0 not found: Serial ATA, SATA-0
Drive 3 not found: Serial ATA, SATA -3
Drive 5 not found: Parallel ATA,PARA-1 (PRI IDE Slave)
etc, etc, then:
RAID Volumes:
0 ARRAY RAID0(stripe) 128kb 298GB Failed No
Physical Drives:
1 ST 316****** etc 149 GB Member Disk (0)
2. WDC******* etc 931GB Non-RAID Disk
Strike F1 or F2, etc.....
Please can you suggest what I can try next?